Upgrade Band Saw Urethane Tires – 14″ x 1″ x .095″ (2 Pack) Compatible with Jet, Grizzly, and Powermatic Band Saws

A little bit of work to get on, but the right method makes all the difference. Runs like new again.
I don’t do much woodworking anymore because of a disability, and I miss it, but when my bandsaw went down due to the tires on the pulleys getting deteriorated to a point to where they broke, I really missed my bandsaw. I had forgotten how often I used this for so many tasks that the band saw makes so easy. I picked up this replacement set of polyurethane tires, not wanting to go back to rubber, although the rubber ones have lasted a dozen years or more, I just wanted to buy one last set and not have to worry about how long they were going to last me. I’ve included a little video explaining what method worked best for me, but I didn’t necessarily go through a video showing the process, but trust me, if you follow what I mentioned in the video you’ll get these on without much trouble. They work as they should and make my band saw operate like it was brand new again. I’m very happy that I chose these ones and that they went on with such relative ease.

it Worked!
Timely received at reasonable price. Had no problems installing. would buy again

Good quality
Working as expected so far. They are a bit challenging to put on, but that is to be expected if they are going to be tight and not slip.

Installation not nearly as difficult as I imagined.
These fit my Jet 14 inch bandsaw perfectly. They were a bit of a challenge to install but not nearly as bad as I expected based on some other reviews. I used a couple spring clamps to hold the tire in the groove on the wheel and two large screwdrivers to stretch and slide the tire onto the wheel as I worked one of the clamps the rest of the way around. Before pulling the screwdriver out after completing the circle I replaced it with a round shaft Phillips screwdriver driver and pulled that around the wheel under the tire a couple times to even out the tension. The first wheel took about 15 minutes with the learning curve but the second one only took 5 minutes. Saw runs much more smoothly with no vibration. Any sawdust on the wheel after running can be easily brushed off so it doesn’t continue to pack and build up.

As described

Quedaron al tamaño, sólo hubo que recortar un poco en lo ancho..

Perfect for my axminster at2552b, I had a bad vibration and oscillating blade back and fore on all blades, these tyres completely eliminated the vibration and blade movement.